product-images-1
product-images-2s

EPOC-131HP-O

Ethernet/PoE Over 2-Wire Extender, IP66, 50W power output, 6000 meters POE, LED indicator, Watchdog timer, 128 Bits AES, Daisy Chain configuration.

Surge With 6KV@102/700μS Differential mode for signal and 2KV @ 1.2/50μS for power surge protector, shields IP camera from surges in electrical power or lighting.
IP 66 IP66 rate waterproof housing protected from dust and low pressure jets of water in all directions.
Watchdog Timer Support S/W & H/W Watchdog timer, it is an embedded timing device that automatically prompts corrective action upon system malfunction detection.


Fast Ethernet/PoE over UTP cable

I-View’s model EPoC-131HP-O IP66 Waterproof outdoor type Ethernet / PoE Transmitter system is a compact media converter that allows 10/100 Base-T Ethernet and PoE+ power up to 50w (DC12V/4.1A) to be transmitted using virtually any kind of cable. This means that you can utilize a Coaxial cable or any two-wire cable (Telephone line, bell wire, power cable and LAN cable, for instance) for the Ethernet / PoE Transmission and also used in legacy installations where existing cable is re-deployed as part of an upgrade to IP cameras without having to lay any new cables or implement any other constructional measures.
The EPoC-131HP-O EPoC system is required at both ends of the cable, and it automatically configures itself as either the transmitter or the receiver, The significant additional benefit of system is that, in addition to data, the power to operate PoE end devices can also be transferred via the two-wire cable.
And now with PoE over 2-wire, you can deliver up to 50 watts (DC12V/4.1A) of PoE power to the camera as well, eliminating the complexity of installing local power supplies. It is hard to predict or measure the length and quality of installed cable, so it is very important to deliver continuous, reliable power for the new IP camera that the cable you are upgrading. However, thanks to EPoC-131HP-O system’s High-power design, maximum can support a 50 watt to IP devices at the most range likely to be found in a legacy installation.

 
Friendly status indicator

The smart LED indicators provide an instant and easy-to-understand confirmation of network, power status and right across the cable, with no need to visit remote equipment site to check connections. And once connected, the LED indicator for power display instantly reaffirms that the actual power available to the camera is sufficient.

 
Add power easily

DC plug connections, or the option of using a PoE Hub source, You can use the power source from the PoE Hub or DC power adapter provides the last link in assuring continuous power delivery, without configuration or measurement required, installation of is as straightforward as plugging it in. If PoE is not available, or for an extra power boost at either end of the cable, just connect the optional power supply.

 
Features
  • Transmit up to network speeds up to 150 Mbps*; distance Up to 1,968ft (600m)**.
  • Re-use existing coax or two-wire cable for IP cameras.
  • Adapter set to transfer via Ethernet and PoE using a UTP cable.
  • Easy to install, no IP and MAC address configuration required.
  • Support Daisy chain and Start system configuration.
  • Built-in Watchdog can auto reconnect when system connection fails.
  • Support any 10/100 Base-T Ethernet device, including IP cameras.
  • Support up to 50W (DC12V/4A) power output.
  • Instantly check network signals, link and power status with LED indicators.
  • 128-bit AES encrypted communication for transient protection.
Note:
*The above test result table that is NO GUARANTEE of possible cable lengths, data rates and power transmission,
as various physical factors are not within the area of responsibility of I-View. The nominal data rate, connection length
and power transmission can only be individually tested and determined at the place of installation.
**The Power/Distance Calculator can be found at www.i-view.com.tw
 
Applications
● Upgrading to IP

Retrofit analog CCTV installations into digital systems, delivering full network connectivity and standardized, centrally-sourced power without re-cabling.

● New installations

With the familiarity of coaxial cable and the reliability and cost advantages of PoE, it is an effective choice for the installation of new IP video systems where cable runs may be longer than standard 10/100 Base-T and hard to get power area.

● Long distance extension

Connecting Ethernet/PoE over 2-Wire Extender system back-to-back allows the network signal to be repeated without local power, enabling extension of Ethernet up to 1500 meters (4,950 feet)

● Networked just there's 2-Wire

The ability to convert 2-Wire into a network connection without requiring power has many advantages in upgrading CATV, satellite or telephone system in hotels or other buildings, among other applications.

● Elevators and mechanisms

Coaxial cable has the advantage being coil and bendable, compare to UTP cable. The Ethernet/PoE over 2-Wire Extender system provides a better solution for network access to elevator carriages, such as Security video, Access controller, VoIP and Digital signage.

 
Data Rate VS. Cable distance
 
Power Wattage VS. Cable Distance
Specification
Ethernet
Connector RJ-45
Connectivity 10/100 Base-T. auto-negotiation, auto MDI/MDX crossover
Wire type Cat.5 or better
Distance Up to 100 Meters (328 feet)
Cable Link
Connector BNC/RJ45
Type Transmitter (Cameras Site)
Wire type Coax, single- or multi-pair UTP, 18/2, or STP wire
Distance* Up to 1.5Km (4950 feet)
Topology Supports Star, Daisy-Chain or any other combination
Encryption 128-bit AES
Latency 3 ms
Bandwidth Total network bandwidth 150 Mbps; with dynamic bandwidth allocation*
Power
Power Source
None
Power Output 50W (DC12V/4A) Termainal block
Physical
Waterproof
IP 66
Dimensions (mm)
128 x 102 x 36
Weight
310 g
LEDs
Status indicators

Cable link
Ethernet Power
POE connection
Ethernet link/activity

Environment
Temperature
-5℃~50℃/23°F~122°F (Standard); -40℃~60℃ / -40°F~140°F (Optional: Built-in heater controller)
Humidity 20% ~ 85% non-condensing
Power consumption
≤ 2W
Transient immunity
20µS x5 3,000A, 6,000V; ESD 20KV, 200pF
Accessories
See the ordering information
Certificated
  CE, FCC, RoHS.
*Distance and number of devices supported may be lower due to power supply capacity and wire voltage-drop. The bandwidth is dynamically allocated (shared based on traffic), and decreases with wire distance.
*Product specifications are subject to change without notice.
*EZLink is trademark of I-View Communication Inc.; All others trademarks are belonging to the respective owners.
Diagram-EPoC
Accessories Features
RMP-419 19 Inches Mount Panel
  • Allow 4 sets EPoC/EoC devices in 1 U high of 19"cabinet.
  • Combine with EPoC/EoC devices flexibly.
  • Maintain easily with modularized design.
  • Save maintenance costs by swapping EPoC/EoC module.
  • Suit for 4pcs EoC-100V, EoC-410V, EPoC-131VA and EPoC-131VAJ, EPoC-151VA units.
 
WH-100B Waterproof Housing
  • IP 66 design best for the outdoor application.
  • Suit for EoC-100V, EPoC-131PS, EPoC-31PS and EPoC-131PSJ unit.
Order Information
EPoC-151VA:Giga Ethernet /PoE Receiver over Coax/ UTP/ 2-Wire cable. 
EPoC-151PS:Giga Ethernet /PoE over 2-Wire Transmitter supports DC12V/1A power output.
EPoC-151HP:Giga Ethernet /PoE over 2-Wire Transmitter with 50W (DC12V/4A) power output.
EPoC-151VAJ:Ethernet /PoE Receiver over UTP or 2-Wire cable. 
EPoC-151PSJ:Ethernet /PoE Transmitter over UTP or 2-Wire cable.
EPoC-151PSJ-O:IP 66 Waterproof Ethernet /PoE Transmitter over UTP or 2-Wire cable.
EPoC-131VA:Ethernet /PoE over Coaxial cable Receiver.
EPoC-131PS:Ethernet /PoE over  Coaxial cable Transmitter.
EPoC-151PSJ-O:IP 66 Waterproof Ethernet /PoE Transmitter over coaxial or 2-Wire cable.
EPoC-131HP-O:IP 66 Ethernet /PoE over 2-Wire Transmitter support DC12V/4V (50W) power output.
PW-4805A:DC48V/0.5A power supply for PoE power input source.
PW-4813A:DC48V/1.35A power supply for PoE power input source.
PW-5613A:DC56V/1.28A power supply for PoE power input source.
WH-100B:Wall mount waterproof box for EoC-100V, EPoC-131PS, and EPoC-131PS unit.
RMP-419:19 inches Rack Mount Panel for 4pcs EoC-100V, EoC-410V, EPoC-131VA, EPoC-151VA units.
TBNC-01:T-type BNC connector.
BTB-100:BNC to Terminal block converter.
BRK-001:
The Bracket allows EPoC-131PS, EPoC-131PSJ to be placed between a box camera and camera housing and it’s mount.

    Document typeFile DescriptionProduct NameRelease dateVersionSize DownloadDownloadNote

  • .pdfEPOC_131HP-O Operation Menu_V1_2.pdfEPOC-131HP-O Ethernet over 2-Wire Transmitter Operation Menu2015/11/30V1.2544.0kdownloadNote
    This menu file for Outdoor type EPOC-131HP-O Ethernet/PoE over 2-Wire Transmitter product.
  • .pdfGiga_EPoC Extender_.pdfGiga Ethernet/PoE over 2-Wire Datasheet2016/02/19V1.12,001.3kdownloadNote
    The Giga Ethernet/PoE Extender Datasheet, the datasheet is including EPoC-151VA,EPOC-151PS, EPoC-151HP product models.
  • .PDFJoined Group software Menu.pdfEPoC Join Group Operation Menu2015/05/15V1.2250.6kdownloadNote
    This manual suits for all EPoC over 2-wire product series to join a group with 128 bits AES encryption transmission which devices connect to the same cable.
  • .pdfEPoC over 2-Wire Extender system.pdfEthernet/PoE over 2-Wire Datasheet2015/11/30V2.12,226.0kdownloadNote
    The Datasheet has be including EPOC-131VA, EPOC-131VAJ, EPOC-131PS, EPOC-131PSJ, EPOC-131PS-O, EPOC-131PSJ-O and EPOC-131HP-O product models.
  • .PDFCase studies.pdfEthernet/PoE over 2-Wire Case study2015/08/19V1.01,310.9kdownloadNote
    You can refer the EPoC product series application from this document file.
  • .pptxEPoC_EoC systems introduction.pptx.pptxEthernet/PoE over 2-Wire Presentation file2015/08/19V 2.12,622.0kdownloadNote
    The presentation material for Ethernet/PoE over 2 Wire ad EoC Ethernet over Coax Extender product series.
  • .rarJoin Group.rarJoin Group configuration software2015/05/15V1.15,037.4kdownloadNote
    This software supports Join Group function for Ethernet/PoE over 2-Wire transmission system series which devices connect to the same cable to avoid the interference problem.