Why the monitor shows the "Blue Screen" when I use the AnyNet NVR with Raid card?

The problem causes the HDDs had been partition before to change the BIOS setting after you plug into for Raid function. Please do the process as below:


1.Entry the BIOS of NVR and check the BIOS setting as below diagram.

2.Click “Exit/Advanced Mode” and then select “Advanced Mode”.

3.Change the “Advanced\ SATA Configuration” setting as IDE mode.

4.Select the “Boot\ Hard Drive BBS Priorities” Let “Boot Option #1” change to Flash Module or SSD Card and then go back preview page.

5.Then  Change “Boot Option #1” to DVD,“Boot Option #2” to SSD Card of Flash Module.

6.Exist & Save the BIOS setting.

Back